Orhan Ergun No Comments

What is attachment circuit in MPLS VPN ? Definitions are important in networking, if there are alternative usages of the definition, better to know them all for effective communication.

 

attachment circuit

MPLS Layer 2 VPN Topology

 

In the above topology, I share, MPLS Layer 2 VPN Topology. There are many terminology but let’s focus on Attachment Circuit in this post.

 

If you look at the link between PE and CE devices, written as ‘ AC ‘

 

AC stands for Attachment Circuit.

 

By the way, I recommend you to read  ‘ what does PE- CE mean ‘ post for the MPLS Layer 3 VPN definition.

 

Attachment Circuit as a term is used in MPLS Layer 2 VPN specifically.

 

It is used to describe the PE (Provider Edge) and the CE (Customer Edge) physical or logical circuit. Logical circuit can be a tunnel , sub-interface , etc.

 

In MPLS Layer 2 VPN, Attachment circuit is connected to PW in Ethernet over MPLS (Point to Point) and VPLS (Multi point to multipoint) or associated with the BGP in MPLS Layer 2 EVPN.

 

On top of Attachment Circuit, spanning tree can run , or any other layer 2 control plane, such as VPLS , Ethernet over MPLS , Link Aggregation Group etc.

 

So, if there are two links between customer equipment and the provider edge device, two of those attachment circuits can be placed in a bundle which is known as Link Aggregation Group (Ether-channel, Port-Channel are the Cisco terms for LAG)

 

Conclusion :

AC , Attachment Circuit , is a physical or logical circuit between PE and CE devices and used in MPLS Layer 2 VPN. In MPLS Layer 3 VPN, that link is mostly called as just PE-CE link and since in MPLS Layer 3 VPN, Routing Protocol runs between PE and CE link, a routing protocol in that case is called as PE-CE Routing Protocol or Customer Routing Protocol.

 

Leave a Reply

Your email address will not be published.